Hardware |
Controller |
High Performance Microcontroller |
RTC (Real Time Clock) |
No |
Watchdog |
Watchdog IC |
ESD Protection |
4 kV Contact for each channel |
CAN Interface |
Transceiver |
NXP TJA1042 |
Channel number |
4 |
CAN Connector |
9-pin male D-Sub with CAN_GND, CAN_SHLD, CAN_H, CAN_L |
CAN Specification |
ISO-11898-2, CAN 2.0A and CAN 2.0B |
Baud Rate (bps) |
5k, 10 k, 20 k, 33.3 k, 50 k, 62.5 k, 83.3 k, 125 k, 250 k, 500 k, 800 k, 1 M bps and
user-defined |
Baud Rate Selection |
Selectable by rotary switch |
Isolation |
3000 VDCfor DC-to-DC, 2500 Vrms for photo-couple |
Terminator Resistor |
Selectable 120O terminator resistor by internal jump |
Transmission Distance (m) |
Depend on baud rate (for example, max. 1000 m at 50 kbps ) |
CAN Filter |
Configurable by user |
UART Interface |
RS-232 |
1 port (for configuration) |
RS-232 Connector |
9-pin screwed terminal block (TxD, RxD, GND ) |
LED |
Round LED |
CAN status LED x 4 , Power LED x 1 |
Power |
Input range |
Unregulated +10 ~ +30 VDC |
Power Consumption |
1.5W |
Mechanism |
Installation |
Wall-Mounting |
Casing |
Aluminum metallic case |
Dimensions |
116.5 x 127 x 61.3 mm (W x L x H) |
Environment |
Operating Temp. |
-25 ~ 75 ? |
Storage Temp. |
-30 ~ 80 ? |
Humidity |
10 ~ 90% RH, non-condensing |
ESD protection |
4 kV Contact for each channel |
EFT protection |
500V for signal, 1000V for power |
EMI certification |
30M ~ 1G pass |
Hi-pot protection |
1kV pass |
Surge protection |
1kV pass |