TP-DCDC-1224G-4P - Gigabit 9-36VDC IN 24VDC 4 Pair PoE OUT 24W DC to DC Converter and PoE inserter
by Tycon Systems

TP-DCDC-1224G-4P is the Gigabit DC to DC converters offered by Tycon Power Systems are a low cost and high efficiency solution for those requiring 24VDC 4 pair Passive Power over Ethernet from a 12VDC or 24VDC voltage source like a battery system or vehicle. TP-DCDC-1224G-4P have an integrated 4 pair PoE injector to apply the power and data output to the CAT5 Ethernet cable. All 8 wires carry both data and PoE power. The output voltage is regulated and protected. TP-DCDC-1224G-4P have two isolated inputs for connecting 2 power sources, like a primary and backup power source. Input and outputs are isolated so + or – ground is OK. They accept gigabit data-in to a shielded RJ45 Jack and provide gigabit data-out and 4 pairt PoE power on the shielded RJ45 output jack. They work by supplying power on Ethernet pins 1,2,4,5(V+) and 3,6,7,8(V-). They have various protections for surge, short circuit and overload. The units have power outputs up to 24W.

DC Input Voltage	9VDC – 36VDC, Input/Output is Isolated
DC Input Connector	Removeable Screw Type Compression Wire Terminal (12 AWG Max)
DC Output Voltage	24V (Passive) 4 pair power
Data in & Data/POE Output Connector	RJ45 (Shielded)
Output Current (max)	1A
Output Power (max)	24W
Low Voltage Disconnect / Reconnect	Disconnect at 8.9V, Reconnect at 9.02V
Efficiency (min)	80%
Line Regulation	1%
Load Regulation	5%
Ripple	1%
Noise	1%
LED Operation	RED = Input Power On, GREEN = Output Connected
Surge Protection (IEC 61000-4)	15kV (Air), 8kV (Contact), 20A (8/20us) Lightning
EMC Standards	FCC Class B EN55022 Class B
Safety Standards	UL1950, CSA 22.2 &TUV EN60950
Operating Temp	-40 to +70°C (-40 to +158°F)
Operating Humidity	5% -90%
Storage Temp	-40 to +80°C (-40 to +176°F)
Dimensions (LxWxH)	125 x 75 x 38mm (4.9 x 3 x 1.5”)
Weight	300g (10.6oz)

TP-DCDC-1224G-4P.pdf

245 K