The Patton Model 1000M RJ11 supports asynchronous, point-to-point, RS-232, communication over two twisted pairs. The Model 1009 will plug into DB-9 and the Model 1000 plugs directly into a DB-25 interfaces. Both modems are backwards compatible with each other. This short haul is compatible with the Patton Model 1010.
Transmission Format: Asynchronous
Data Rate: 0 to 19,200 bps (no strapping)
Range: 17 Miles (27.4 Km) on 19 AWG @ 1200 bps
Control Signal (Model 1009):CTS (Pin 8) turns ON immediately after the terminal raises RTS (Pin 7); DSR (Pin 6) and DCD (Pin 1) turn ON immediately after the terminal raises DTR (Pin 4)
Control Signal (Model 1000): CTS (Pin 5) turns ON immediately after the terminal raises RTS (Pin 4); DSR (Pin 6) and DCD (Pin 8) turn ON immediately after the terminal raises DTR (Pin 20)
Transmit Line: 4 wire, unconditioned line (2 twisted pair)
Transmit Mode: Full duplex, 4-wireTransmit Level: 0 dBm
Device Connection: (Model 1009) DB-9 ; (Model 1000) DB-25
Line Connection: RJ-11 or RJ-45 jack or 5 screw terminal posts (4 wires and 1 ground) and a strain relief insert; works well with data signals only
Power: None required, uses ultra low power from EIA data and control signals
Dimensions: (Model 1009) 2.50" x 1.2" x 0.75" ; (Model 1000) 2.20" x 1.75" x 0.75"
