The I-7088 has 8 PWM output channels and 8 counter inputs and can be used to develop powerful and cost effective analog control systems. PWM (Pulse width modulation) is a powerful technique for controlling analog circuits that uses digital outputs to generate a waveform with variant Duty Cycle (The fraction of time that a system is in an "active" state) and frequency to control analog circuits and can be used to control the position/speed of motors, dim the brightness of lamps, control the speed of fans, etc.
The I-7088 will also automatically save the counter value to EEPROM if the power supply is interrupted or lost.
- Automatic hardware generation of PWM outputs without software intervention
- 1Hz ~ 500KHz PWM output frequency with 0.1%~99.9% duty cycle
- Software and hardware trigger mode for PWM output
- Individual and synchronous PWM output. Using software trigger mode, you can set the configuration for all PWM channels then trigger them individually or all of them at the same time.
- Burst mode PWM operation for standby
- DI channel can be configured as either a simple digital input channel or a hardware trigger source for the PWM output.
PWM Output |
Channels |
8 |
Type |
TTL, Isolated |
Max. Frequency |
1Hz ~ 500Khz |
Duty Cycle |
0.1% ~ 99.9% |
PWM Mode |
Burst mode, Continuous mode |
Burst Mode Counter |
1~65535 counts |
Trigger Start |
Hardware or Software |
ESD Protection |
4 kV Contact for each terminal and 8 kV Air for random point |
Isolation |
2500 VDC |
Digital Input |
Channels |
8 |
Type |
Sink, Isolated |
ON Voltage Level |
+3.5V ~ +5V |
Off Voltage Level |
+1V Max. |
Max. Frequency |
1MHz |
Max. Counts |
32-bits (4,294,967,295) |
Built-in Virtual Battery Backup for Counter Value |
Yes |
ESD Protection |
4 kV Contact for each terminal and 8 kV Air for random point |
Isolation |
2500 VDC |
Interface |
Interface |
6 |
Format |
Sink or Source, Isolated channel with common power or ground |
Baud Rate |
+1V max. |
LED Display |
1 LED as Power/Communication Indicator
|
Power |
Input Voltage Range |
10 ~ 30 VDC |
Power Consumption |
2.4 W (max.) |
Power Reverse Polarity Protection |
Yes |
+/- 4 kV ESD , +/- 4 kV EFT and +/- 3 kV Surge |
Yes |
Environment |
Operating Temperature |
-25°C ~ +75°C (-13°F ~ +167°F) |
Storage Temperature |
-40°C ~ +85°C (-40°F ~ 185°F) |
Humidity |
5 ~ 95%, non-condensing |
|