| CAN Interface |
| Connector |
Screwed terminal block (CAN_GND, CAN_L, CAN_H) |
| Baud Rate (bps) |
10 k ~ 1 M |
| Baud Rate (bps) |
10 k ~ 1 M |
| Transmission Distance (m) |
Depend on baud rate |
| Terminator Resistor |
Switch for 120O terminator resistor |
| Isolation |
2500 Vrms on the CAN side |
| Specification |
ISO 11898-2, CAN 2.0A and CAN 2.0B |
| Propagation Delay |
190 us *Note2 |
| Fiber Interface |
| Type |
SC type ; Single mode ; 100 Base-FX |
| Wave Length (nm) |
TX: 1310, RX: 1550 for I-2533CS-A
TX: 1550, RX: 1310 for I-2533CS-B
|
| Fiber Cable (µm) |
8.3/125, 8.7/125, 9/125 or 10/125 |
| Transmission Distance (km) |
15 (indicative only), (9/125 µm recommended) |
| Min. TX Output (dBm) |
-8 |
| Max. TX Output (dBm) |
-14 |
| Max. RX Sensitivity (dBm) |
-31 |
| Max. RX Overload (dBm) |
0 |
| Budget (dBm) |
23 |
| UART Interface |
| COM1 |
RS-232 (configuration only) |
| COM1 Connector |
Screwed terminal block (RXD, TXD, GND) |
| LED |
| Round LED |
PWR, FB_Ack, FB_Err, CAN_Err, CAN_Tx and CAN_Rx LEDs |
| Power |
| Power supply |
Unregulated +10 ~ +30 VDC |
| Protection |
Power reverse polarity protection, Over-voltage brown-out protection |
| Power Consumption |
0.125 @ 24VDC |
| Mechanism |
| Installation |
DIN-Rail |
| Dimensions |
33.0 mm x 126 mm x 101 mm (W x L x H) |
| Environment |
| Operating Temp. |
-25 ~ 75 ? |
| Storage Temp. |
-30 ~ 80 ? |
| Humidity |
10 ~ 90% RH, non-condensing |
