ICP DAS ISO-AD32H/S - ISO-AD32H with DN-37
by ICP DAS

The ISO-AD32H/L ( H for high gain / L for low gain ) is a bus-type isolated 12-bit A/D board for PC/AT compatible computers. The isolation inputs can operate with up to 500Vrms of common-mode voltage. The ISO-AD32H/L features a 200KHz 12-bit analog-to-digital converter, on board 1K byte FIFO buffer, and 32 singled-ended or 16 differential analog input channels. The analog input allows auto-channel /gain scan . This board supports gap-free A/D conversion at 200KHz sampling rates for single channel or 100KHz sampling rates for channel scan . The "Hands-Off" design permits all board parameters (channel selection, gain, input type, and operating mode) to be performed with software . Once installed, you will never have to configure it again.

• Fast Speed -- up to 200KHz
• Sampling rate can be programmable
• On board FIFO buffer supports gap-free A/D conversion
• High channel count input can be implemented in half size
• 32 single-ended or 16 differential input channels, 500Vdc photo-isolation protection
• Maximum 200K 12-bit sampling rate
• Built-in 1K byte FIFO
• Auto-channel / gain scan
• Command set programming
• Gap-free A/D conversion
• Software:
  • Toolkit for DOS
  • Toolkit for Windows 95/98
  • Toolkit for Windows NT
  • Toolkit for Windows 2000/XP
  • Toolkit for Labview 95/98
  • Toolkit for Labview NT
  • Toolkit for Labview 2000/XP
  • Toolkit for OCX 95/98
  • Toolkit for OCX NT
  • Toolkit for OCX 2000/XP
  • Toolkit for LINUX
  • Toolkit for DasyLab

• Channels: 32 single-ended / 16 differential
• Resolution: 12-bit
• Conversion rate: 200KS/s max.
• Input impedance: 10000M Ohm // 6pf
• Overvoltage protection: +/- 35V
• Accuracy: 0.01% of reading +/- 1-bit

• General Environment:
  • Power Requirements: +5V @850mA max.
  • Operating temp 0° - 50°C
  • Storage temp -20°C - 70°C
  • Humidity 0 to 90% non-condensing
  • Dimensions 173 mm x 122 mm