I-7580_DESCRIPTION.html
The I-7580 is a PROFINET IO device with RT functionality that supports RS-232, RS-422 and RS-485 serial interfaces. Users can choose one of these serial communication interfaces to apply. It is easy to allow users to take almost serial device to a PROFINET network including serial remote I/O devices, sensors, actuators, HMI, barcode readers and RFID, etc.
I-7580.html
| Hardware
|
| CPU
|
32-bit CPU Core
|
| RAM/Flash/EEPROM
|
32 MB / 4 MB / 8 KB
|
| Watchdog
|
CPU built-in
|
| ESD Protection
|
4 kV class A
|
| PROFINET Interface
|
| Protocol
|
PROFINET IO Device
|
| Conformance Class
|
Class B
|
| Service |
RTC, RTA, CL-RPC, DCP, LLDP, I&M |
| Cycle
|
1 ms (min)
|
| Ethernet Interfance
|
| Controller
|
10/100Base-TX Ethernet Controller (Auto-negotiating, Auto_MDIX)
|
| Connector |
RJ-45 x 2 (LED indicators) , Integrated 2-Port Switch |
| Service
|
ICMP, IGMP, ARP, DHCP, TELNET, TFTP, SNMP, VLAN Priority Tagging
|
| UART Interface
|
| COM |
RS-232/RS-422/RS-485 (can\'t be used simultaneously) |
| COM Connector |
3-pin screwed terminal block (RxD, TxD, GND)
4-pin screwed terminal block (RxD+,
RxD-, TxD+, TxD-)
2-pin screwed terminal block (DATA+, DATA-) |
| Baud Rate (bps) |
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400, 460800 |
| Data bit
|
7, 8
|
| Stop bit
|
1
|
| Parity
|
None, Even, Odd
|
| LED
|
| Round LED
|
AP LED, BOOT LED, ERR LED
|
| Power
|
| Power Supply
|
Unregulated +10 ~ +30 VDC
|
| Protection
|
Power reverse polarity protection, Over-voltage brown-out
protection
|
| Power Consumption
|
3.4 W
|
| Mechanical
|
| Installation |
DIN-Rail |
| Dimension
|
42 mm x 76 mm x 119 mm (W x L x H)
|
| Environment
|
| Operating Temperature |
-25C ~ +75C (-13F ~ +167F) |
| Storage Temperature |
-30C~+80C (-22F~+176F) |
| Humidity |
10 ~ 90% RH, non-condensing |
|
