Need assistance or guidance?

Contact us @: 1-800-301-9097
Login / Register Contact Us
 
TGAP-W610+-M12 - EN50155 Rugged 1x10/100/1000Base-T(X), M12 connector (PSE) to 802.11a/b/g/n wireless access point by ORing Industrial Networking

TGAP-W610+-M12 - EN50155 Rugged 1x10/100/1000Base-T(X), M12 connector (PSE) to 802.11a/b/g/n wireless access point
by ORing Industrial Networking

Write a review Write a review
  • High Speed Air Connectivity: WLAN interface support up to 300 Mbps link speed
  • Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/ WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
  • Support Long Distance Air Connectivity
  • Support Multiple-SSID to 4 SSID
  • Support X-Roaming < 60 ms
  • Support wireless load balance
  • Support external N-Type antenna installation
  • Support AP/ Client /Bridge /AP-Client Mode
  • Support MAC/IP/Port Filter
  • Wireless connecting status monitoring
  • Secured Management by HTTPS
  • 1KV isolation for PoE P.D.
  • Event Warning by Syslog, Email, SNMP Trap, and Relay output
  • Rigid IP-67 waterproof housing design
TGAP-W610+ is a reliable outdoor wireless Access Point with IEEE 802.11 a/b/g/n wireless modules and 1 Ethernet Gigabit port with PoE P.D.. It can be configured to operate in AP/ Client /Bridge /AP-Client Mode and supports MAC filters for security control. TGAP-W610+ provides a dust-tight connection and four N-Type connectors that can install any N-Type antennas to extend communication distance. It is specifically designed for the toughest industrial environments. You are able to configure TGAP-W610+ by WEB interface via LAN port or WLAN interface. In addition, TGAP-W610+ also provides P.D. feature that is fully compliant with IEEE802.3af PoE P.D. specification to save the layout cost of power line. TGAP-W610+ can be easily adopted in almost all kinds of applications and provides the most rugged solutions for managing your network in outdoor. Therefore, TGAP-W610+ is one of the best communication solutions for wireless applications.
Physical Ports  
10/100/1000Base-T(X)
Auto MDI/MDIX

1 (M12 8-pin A-coding)

 

PoE P.D. port Present at ETH
Fully compliant with IEEE 802.3af Power Device specification
Over load & short circuit protection
Isolation Voltage: 1000 VDC min.
Isolation Resistance : 108 ohms min
WLAN interface    
Operating Mode P/Dual Client /Bridge /AP-Client Mode
Antenna and connector 2 x External N-Type female antenna connector
Radio Frequency Type DSSS, OFDM
Modulation IEEE802.11a : OFDM with BPSK, QPSK, QAM, 64QAM 
IEEE802.11b: CCK, DQPSK, DBPSK
IEEE802.11g: OFDM with BPSK, QPSK, 16QAM, 64QAM
IEEE802.11n : BPSK, QPSK, 16-QAM, 64-QAM
Frequency Band

America / FCC :  2.412~2.462 GHz (11 channels)

5.180~5.240 GHz & 5.745~5.825 GHz ( 9 channels )

Europe CE / ETSI : 2.412~2.472 Ghz (13 channels)
5.180~5.240 GHz (4 channels)

Transmission Rate IEEE802.11b: 1 / 2 / 5.5 / 11 Mbps
IEEE802.11a/g: 6 / 9 / 12 / 18 / 24 / 36 / 48 / 54 Mbps 
IEEE801.11n: up to 300Mbps
Transmit Power 802.11a: 12dBm ± 1.5dBm@54Mbps
802.11b: 17dBm ± 1.5dBm@11Mbps
802.11g: 16dBm ± 1.5dBm@54Mbps
802.11gn HT20: 15dBm ± 1.5dBm @MCS7
802.11gn HT40: 14dBm ± 1.5dBm @MCS7
802.11an HT20: 12dBm ± 1.5dBm @MCS7
802.11an HT40: 11dBm ± 1.5dBm @MCS7
Receiver Sensitivity 802.11a : -76dBm ± 2dBm@54Mbps
802.11b : -85dBm ± 2dBm@11Mbps
802.11g : -76dBm ± 2dBm@54Mbps
802.11gn HT20:-75dBm ± 2dBm@MCS7
802.11gn HT40:-72dBm ± 2dBm@MCS7
802.11an HT20:-74dBm ± 2dBm@MCS7
802.11an HT40:-71dBm ± 2dBm@MCS7
Encryption Security

WEP: (64-bit ,128-bit key supported)
WPA/WPA2 :802.11i(WEP and AES encryption)
WPAPSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption

Wireless Security SSID broadcast disable and enable
Protocol Support    
Protocol ARP,BOOTP, DHCP, DNS, HTTP, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP, RSTP
LED Indicators    
Power Indicator 3 x LEDs, PW1/PW2/PoE Green On : Power is on
10/100/1000TX M12 Port Indicator 1 x LEDs, Green for port Link/Act
WLAN LED 1 x LEDs, Green for WLAN Link /Act
Fault  
Power Dual Power Inputs. 12~48 VDC  
Input power    
Redundant Input Power    
Power Consumption (Typ.) 9Watt  
Physical Characteristic    
Enclosure IP-67
Dimension (W x D x H) 310 (W) x 310(D) x 87 (H) (12.2 x 12.2 x 3.4 inch)
Weight (g) 3900g  
Environmental  
Storage Temperature -40 to 85°C (-40 to 185°F)
Operating Temperature -25 to 70°C (-13 to 158°F)
Operating Humidity 5% to 95% Non-condensing
Regulatory approvals    
EMI FCC Part 15, CISPR (EN55022) class A, EN50155 (EN50121-3-2)
EMS EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge), EN61000-4-6 (CS), EN61000-4-8, EN61000-4-11
Shock IEC60068-2-27, EN61373
Free Fall IEC60068-2-31
Vibration IEC60068-2-6, EN61373
Rail Traffic EN50155
Cooling EN60068-2-1
Dry Heat En60068-2-2
Safety EN60950-1

 


Copyright © 2024 iComTech. All rights reserved. Shopping Cart Software powered by ecMidas.